 |  | SIZE:Sorrento luxury hotels 23" Wide x 20" Deep x 30" High | | WEIGHT: 125 lbs. (empty) | | POWER: 115V, 60Hz or 220V, 50Hz | | POWER CONSUMPTION: 60 Watts/hour | | CAPACITY: 16 selections, 84 items. | | | 
| | Exceptional range of products will easily satisfy your guest's desires | 
Specifications & Installation Requirements | - FRONT DESK PC
- The PC should be located in an enclosed ventilated, relatively dust-free environment, and situated either on a table-top or sturdy shelf unit. The PC is to be plugged into the UPS. Which may be on the floor. The UPS, printer and video monitor are plugged into a standard 120 volt duplex outlet.
| | PC and Printer footprint: | 21" deep by 40" wide | | PC and monitor height clearance: | 20" | | UPS input power: | 120 volts AC, 50/60Hz @ Two Amperes | | UPS size: | 7" x 9" x 18" | | Maximum distance from PC to PMS: | 25 feet (Note: Short haul modems may be used to extend this distance) | | Maximum distance from PC to controller: | 250 feet | | Telephone: | RJ-11 dedicated line for incoming calls only. | - HEAD END TRANSCEIVER & CONTROLLER
- The head end transceiver is to be located in the CATV distribution rack near the main riser splitter(s), and the controller is located near the PC.
| | Maximum distance from controller to head end transceiver: | 5,000 feet | | Transceiver input power: | 120 volts AC, 50/60Hz @ 1 Ampere | | Size: | 4" high by 18" wide by 17" deep | | CATV connector: | 'F' type | | Input CATV sensitivity: | -40 dBmV (squelch adjustable) | | hotels in AlbufeiraOutput power to CATV: | +70 dBmV | | Bandwidth: | 200 kHz | | Transmit Frequencies: | 110.9, 111.1 MHz | | Receive Frequencies: | 26.65, 26.85 MHz | | Front Desk Computer Interface: | RS-422, 9 Pin Sub-D connector | | Dimensions: | 23" wide x 20" deep x 30" high | | Weight: | approximately: 125 pounds (empty) | | Ventilation: | Our unit vends from the front, therefore it can be placed as close as one inch to the wall. | | Input Power: | 120 Volts AC, 50/60Hz @ 0.9 Amperes during chill-down cycle. 120 Volts AC, 50/60Hz @ 0.2 Amperes when "off" | | CATV Connector: | ERROR MSG'F' Type. Splitter required in each room for television/in-room movie connection. | | CATV Specifications: | | Input sensitivity: | -40 dBmV (squelch adjustable) | | Output power: | +68 dBmV | | Bandwidth: | 200 kHz | | Receive frequencies: | 110.9, 111.1 MHz | | Transmit frequencies: | 26.25, 26.85 MHz | | For RoomService IISolna albergo aeroportuale operation, the CATV distribution must be traceableto one common feed point. The maximum loss from any room back to the centraldistribution panel cannot exceed 85 dB at 26.75 and 111.0 MHz. No other system maybe sharing, or interfering with the CATV cable within 1 MHz of the two RoomServiceII frequencies. The RoomService II system does not require any CATV line amplifiers,repeaters or tapes. Communication between any room vend unit and the front deskcomputer occurs in an on-demand basis and results in no significant CATV interface sincethe system is not continually polling all the rooms. | -
|
